For professionals and enthusiasts alike.
52323
Nuovo
Invia ad un amico
Destinatario :
* Campi richiesti
o Annulla
Invia ad un amico
Destinatario :
* Campi richiesti
o Annulla
The HY-03S is a single automatic analogue TBU, 19" (48.3cm) rack-mount unit.
The analogue HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid.
The HY-03 retains many of the features of the HY-02 and adds some additional ones. Some of the features of the HY-03 include :
- Fully automatic - adapts to varyingline conditions and has automatic signal limiting.
- Local and remote line hold switching - calls can be remotely switched through a mixing console.
- Momentary or permanent latching remotes can be enabled.
- Balanced mic/line input - 10k ohm balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
- Balanced output - 0dBu low impedance balanced output, with output gain adjustment.
- Mixed output - the output can be a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
- Integrated ring detector - automatic call answering after a pre-determined number of rings.
- Fitted with K-break disconnect detection as standard with an option for dial-tone disconnect using the optional HY-03DTD board. The HY-03DTD board can be configured to disconnect on recognizing the dial tone used in a specific country.
- Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion crystal clear audio.
- 28dB typical line balance rejection.
- Built in power supply with switchable 115V, or 230V, mains input.
- BABT approval compliant with European PTT specifications.
Technical Specification For HY-03 |
|
Audio Specification |
|
Input Impedance - Line Mode (Clean Feed): |
10kΩ balanced 0dB |
Input Impedance - Microphone Mode: |
200Ω balanced |
Clean Feed Limiting Input: |
+4dBu |
Microphone Level Range: |
From 74dB to 40dB adjusted by preset pot |
Bandwidth to Telephone Line: |
250Hz - 4kHz, -3dB ref 1kHz |
Telephone Line Impedance: |
Nominally 600Ω |
Telephone Line Impedance Range: |
300Ω to 1500Ω |
Output Impedance: |
50Ω balanced floating 0dBu |
Output Level Range: |
+8dB to -14dB adjusted by preset pot |
Rejection Ratio: |
45dB on 1kHz tone, typically 28dB on complex waveforms, reference peak level of 0dB |
Ring Detector Sensitivity: |
1 ring to 6 rings |
Power: |
230V 50Hz, or 115V 60Hz. 6W for HY-03. |
|
|
Connections |
|
Mic/Line Input: |
XLR 3 pin female with push button mic/line selection |
Line Output: |
XLR 3 pin male |
Telephone Line: |
RJ11 6/4 socket |
Telephone Handset/Instrument: |
RJ11 6/4 socket |
Remotes: |
9-way D-type socket |
Power: |
IEC mains (CEE22) |